Features

• TDX Roll tooling to form transverse flange (four-bolt) connector installed outboard
• Sixteen forming stations for superior quality
• One additional inboard roll space available for optional tooling
• 7.5 HP motor coupled to an industrial oil bath gear reducer for quiet longevity
• Independent adjustment at each forming station with pre set spring tension
• Heavy duty roller chain (no belts)
• Heavy duty 1 1/4" diameter stress proof roller shafts
• Large heavy duty bearings with inner races to protect roll shafts and extend the life of the machine
• Material capacity of 18 to 26 gauge with no adjustments necessary between gauges
• 6 inch minimum part length with the use of the included small parts feeder
• Roller bearing infeed guides reducing wear from plasma cut edges (optional)
• Forming speed 70 feet per minute

Optional Tooling

• TDX Clip Tooling
• 1 1/8" standard standing "S"
• 1 5/8" two-in-one Standing Seam 16 gauge max
• 1 1/8" three-in-0ne Tap-in lock, standing seam and right angle 18 gauge max
• 2" x  2" angle
• 16 to 20 gauge pocket Pittsburgh lock

The Vicon TDX Roll Former will produce TDC/TDF Flanges in accordance with the charts shown in the SMACNA Third Edition Construction Standards Manual (T-25b Flanged).

Machinery Shown Without Guards for Illustration Purposes Only