This all new Windows® based controller was specifically designed for the Autobrake 2000 and uses a touch-based graphical user interface for quick editing and creation of part programs. With minimal training, operators can quickly learn to dynamically generate part drawings complete with up-to-date bend angles and lines, material handling instructions, plus hemming and radius macros. An internal modem allows our technicians to troubleshoot your Orion Control using a phone line.

Key features of the Orion Control include:

• Intel® Pentium® processor
• 15-inch XGA anti-glare flat panel touch screen
• Integrated industrial computer with internal air circulation
• Western Digital® hard drive with storage for over 1 million part programs
• Windows® operating system
• 64 megabytes of RAM memory
• 2 megabytes of video RAM
• 3-1/2 floppy drive
• 56K fax/modem card
• 40x CD-ROM
• RS-232 serial port
• PC Anywhere
• Ethernet ready - networking capabilities
• Sealed oil-tight enclosure for protection from contaminants
• Pendant mounted allowing front or rear operation

Simple and easy to use best describe the A2000® control. Operators program their parts by entering the bend location and angle: no knowledge of programming is necessary.

Some of the A2000s features are:

• Storage for 255 programs, with 99 operations per program.
• Programmable hemming pressure, allowing both open and closed hems in the same program.
• Automatic overload protection.
• RS232 port standard for uploading and downloading of programs.

Universal Tooling
Every Autobrake comes with continuous upper, lower, and bending tooling included, as well as a complete set of box and pan (Kombi) tooling (1" through 24" widths). Specialty tooling, while seldom needed, is also available to meet your needs.